NetApp NS0-506 dumps - 100% Pass Guarantee!

You have executed the following FC configuration workflow:

1.

Verify IMT supported configuration.

2.

Install VSC for VMware vSphere on a Windows Server.

3.

Add the storage cluster to VSC and set recommended values.

4.

Update host HBA firmware and BIOS.

5.

Provision the LUN.

6.

Manually create an igroup and add the host WWPNs into it.

7.

Map the LUN to the igroup.

8.

Create datastore and its containing LUNS and volumes.

In step 8, you are not able to see the LUNs you provisioned on your storage controller. When you run

igroup showyou see the ESX host's initiators; however, they are listed "not logged in".

What is the problem?

A. You need to configure ALUA.

B. The LUN was not put online.

C. The LUN type is not set to type VMware.

D. You need to configure zoning.

You want to prevent an FCoE frame from being split into two Ethernet frames.

What is the minimum required frame size that will satisfy this requirement?

A. 9216

B. 2240

C. 1512

D. 9000

A storage administrator has the configuration shown in the exhibit.

In which scenario would a volume move be successful?

cl01::>vserver show -vserver svm1 Vserver: svm1 Vserver Type: data Vserver UUID: 1630b8eb-c2a611e4-a7dd-123478563865 Root Volume: svm1_root Aggregate: Node1_aggr1, Node2_aggr1 Name Service Switch: file, nis Allowed Protocols: fcp Disallowed Protocols: nfs, cifs, iscsi, ndmp Is Vserver with Infinite Volume: false QoS Policy Group: cl01::>vserver show -vserver svm2 Vserver Type: data Vserver UUID: 1630b8eb-c2a611e4-a7dd-123478563412 Root Volume: svm2_root Aggregate: Node1_aggr1, Node2_aggr1, Node1_aggr2 Name Service Switch: file, nis Allowed Protocols: fcp Disallowed Protocols: nfs,

cifs, iscsi, ndmp Is Vserver with Infinite Volume: false QoS Policy Group: cl01::>

A. from svm1 aggregate Node1_aggr1 to svm1 aggregate Node2_aggr1

B. from svm1 aggregate Node1_aggr1 to svm2 aggregate Node1_aggr2

C. from svm2 aggregate Node1_aggr1 to svm2 aggregate Node1_aggr2

D. from svm1 aggregate Node1_aggr1 to svm1 aggregate Node1_aggr2

Exhibit

cl01::>lun resize -vserver svm1 -volume db1_vol -lun db1 -size 4096g Error: command failed: New size exceeds this LUN's initial geometry cl01::>

What is the reason for the error shown in the exhibit?

A. The LUN is thin provisioned, but the parent volume is thick provisioned and cannot satisfy the request.

B. The aggregate over commitment threshold has been exceeded.

C. The parent volume that contains the LUN is out of space.

D. The LUN cannot be grown past its maximum resize size.

You are asked to configure the Service Processor on a newly installed node, and must verify the following command:

system-service processor network modify -node local -address-family IPv4 -enable true -ip-address 192.168.123.98 -netmask 255.255.255.0

Which statement about this command is true?

A. -nodeshould reference the actual node name.

B. The gateway IP address is missing.

C. The Link Local IP Address is missing.

D. IPv6 is required for the SP.